PULS

Power supply unit

FIEPOS series

FPT300 Basic 3AC series

Field AC/DC Power supply unit (PSU) / converter

IO-Link interface

323Vac-552Vac (380Vac / 400Vac / 415Vac / 440Vac / 480Vac / 500Vac / 525Vac nom.; 47-63Hz)
In case of loss of 1-phase device will continue to operate without interruption if loaded below limits (see documentation)
3 x 320Vac turn-ON voltage
3 x 300Vac shutdown voltage

"DC-OK" LED

3-phase (3AC)

12.5A (at 24Vdc)

300W (-25...+55°C)
150W at +70°C (derates linearly between +55°C and +70°C)
450W short term (for 60s; at -25...+55°C)
600W short-term (for 1s; at -25...+55°C)

24Vdc (fixed voltage)
500mV turn-ON overshoot

25ms (buffer time at 400/480Vac input)

HanQ4/2 connector (INPUT; X1)
5-pin M12 connector (IO-Link interface; X2)
QuickON connector (OUTPUT; X3)

output overvoltage protection (31.8Vdc typ. / 32.5Vdc max.)
Overload / short-circuit current -- 15A max. continuous current / 27A / 22A typ. at heavy overloads (when output voltage falls below 13V) the power supply delivers continuous output current for 2s. Then the output is switched OFF for approx. 18s before a new start attempt is automatically performed. This cycle is repeated as long as the overload exists. If the overload has been cleared the device will operate normally. Load impedance 10mΩ.
Over-temperature protection -- Output shutdown with automatic restart. Temperature sensors are installed on critical components inside the unit and turn the unit OFF in safety critical situations which can happen e.g. when ambient temperature is too high ventilation is obstructed or the derating requirements are not followed. There is no correlation between the operating temperature and turn-OFF temperature since this is dependent on input voltage load and installation methods.
Series / parallel operation -- not possible
Back-feeding loads max. 35V 4J / 32V 2.8J -- The unit is resistant and does not show malfunctioning when a load feeds back voltage to the power supply. It does not matter whether the power supply is ON or OFF. The absorbing energy can be calculated according to the built-in large sized output capacitor.

0.952 (3x400Vac input)
0.95 (3x480Vac input)

IO-Link

Hanging and fixing via integrated keyholes or by screw mounting

1s start-up delay (400-480Vac input)
10ms rise time (nominal input; constant full current load; 0mF load capacitance)
12ms rise time (nominal input; constant full current load; 12.5mF load capacitance)

IP54

W182mm x H272mm x D70mm

Aluminium housing

-25...+55 °C
(with linear derating) +55...+70 °C

0.5A (3 x 400Vac input; full output; symmetrical phases)
0.42A (3 x 480Vac input; full output; symmetrical phases)
2A peak max. inrush (at 3x400Vac / 3x480Vac input)

(3x400Vac input; full output load) 15.1 W
(3x480Vac input; full output load) 15.8 W

(3x400-480Vac input) 0.9

Commercialized

FPT300242008102

(output stage) 18000 μF

CE marking
cULus
IECEE CB Scheme IEC 62368-1 / IEC 61010-2-201
IEC 61010
IEC 60950-1
SEMI F47
VDMA 24364
ROHS
REACH
WEEE
IEC/EN 61558-2-16

(at 40°C; 300W output; 3AC 400Vac input) 235000 hours
(at 40°C; 150W output; 3AC 400Vac input) 312000 hours
(at 25°C; 300W output; 3AC 400Vac input) 664000 hours
(at 25°C; 150W output; 3AC 400Vac input) 882000 hours
(at 40°C; 300W output; 3AC 480Vac input) 195000 hours
(at 40°C; 150W output; 3AC 480Vac input) 293000 hours
(at 25°C; 300W output; 3AC 480Vac input) 551000 hours
(at 25°C; 150W output; 3AC 480Vac input) 829000 hours

IP54 protection
450W continuously for 60s
600W peak 1s
3AC 380-480V Wide-range input
95.2% full load and excellent partial load efficiencies
DIN rail mounting possible (option "D")
Output connected to PE (PELV)
Version without connection to PE on request
Large output capacitors
Not potted
Negligible low input inrush current surge
Full power between -25°C and +55°C
DC-OK relay contact
3 years warranty
The FIEPOS Basic series offers 1 DC output and is available with a power of 300W or 500W.
The IP54; IP65 and IP67 field power supplies are perfect for the decentralized supply of 1-phase or 3-phase systems and machines.
The field power supplies can be easily connected in parallel; e.g.
to increase total performance or realize a reliable redundant system.

100mVpp (20Hz...20MHz; 50Ω)

838000h (at +40°C; 300W output; 3AC 400Vac input; MTBF SN 29500 IEC 61709)
281000h (at 40°C; 300W output; 3AC 400Vac input; MTBF MIL HDBK 217F Ground Benign GB40)
65000h (at 40°C; 300W output; 3AC 400Vac input; MTBF MIL HDBK 217F Ground Fixed GF40)
1421000h (at +25°C; 300W output; 3AC 400Vac input; MTBF SN 29500 IEC 61709)
383000h (at 25°C; 300W output; 3AC 400Vac input; MTBF MIL HDBK 217F Ground Benign GB25)
88000h (at 25°C; 300W output; 3AC 400Vac input; MTBF MIL HDBK 217F Ground Fixed GF25)
814000h (at +40°C; 300W output; 3AC 480Vac input; MTBF SN 29500 IEC 61709)
268000h (at 40°C; 300W output; 3AC 480Vac input; MTBF MIL HDBK 217F Ground Benign GB40)
62000h (at 40°C; 300W output; 3AC 480Vac input; MTBF MIL HDBK 217F Ground Fixed GF40)
1380000h (at +25°C; 300W output; 3AC 480Vac input; MTBF SN 29500 IEC 61709)
366000h (at 25°C; 300W output; 3AC 480Vac input; MTBF MIL HDBK 217F Ground Benign GB25)
84000h (at 25°C; 300W output; 3AC 480Vac input; MTBF MIL HDBK 217F Ground Fixed GF25)